INSTALLING REDIPAVE REFUGE ISLANDS
RediPave is designed to ensure quick and easy installation of highly durable and visible pedestrian refuges and traffic islands, with or without traffic signage.
 |
Put out warning signs and
sufficient traffic management
measures to ensure the
safety of operatives, road
users and pedestrians as per Chapter 8. |
 |
Mark position on road for location of Islands and assemble the RediPave modules accordingly. |
 |
Ensure all module butt joints are tightly together and start from the middle sections of the RediPave. With a 14mm drill bit, drill through the holes to a depth of 270mm from module surface into the road. The drill used will be a Hilti T15 or T21 hammer drill (or similar) attached to a 3 kva generator via a 25 m. 110 v extension lead. |
 |
Blow out fixing holes using a long hosed air gun, powered by a 120psi portable compressor, insert resin commencing at base of hole, 2 to 3 pumps required using a resin gun supplied by Rediweld. |
 |
Insert coach screw through black plastic anchor block and attach Rediplug and tap down to surface level. Tighten with impact wrench; ensuring coach screw is firmly seated. |
 |
Repeat drilling, blowing, resin for remaining middle holes and use the black plastic anchor fixings to secure island. Once middle sections have been completed, drill remaining outside holes and blow out fixings holes using the long nosed air gun. Thoroughly blow out holes and insert resin commencing at base of hole. |
 |
Insert coach screw and plastic washer into Rediplug. Tap assembly down to 70mm above module surface and tighten with impact wrench, ensuring washer is firmly seated. Do not over-tighten. |
 |
Remove all work debris & personal rubbish from site. Remove traffic
management signs and |
